J'essaye de passer ma gentoo au noyau 2.6.24 mais mes périphériques usb ne fonctionne pas
Au ébut rien ne fonctionnait niveau usb mais depuis j'ai mis les drivers qui vont bien et mes périphériques sont detecté, mais ne sont pas utilisable. Pourla souris j'ai testé les diférents I/O de /dev/input, autant celle du portable foctionne autant la souris usb semble n'être relié à aucun fichiers.
Il doit manquer quelque chose mais je ne saispas quoi
Citation :
localhost watchwolf # dmesg | grep usb
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
usb usb1: configuration #1 chosen from 1 choice
usb usb2: configuration #1 chosen from 1 choice
usb usb3: configuration #1 chosen from 1 choice
usb usb4: configuration #1 chosen from 1 choice
usb usb5: configuration #1 chosen from 1 choice
usb 2-1: new low speed USB device using uhci_hcd and address 2
usb 2-1: configuration #1 chosen from 1 choice
usb 3-1: new low speed USB device using uhci_hcd and address 2
usb 3-1: configuration #1 chosen from 1 choice
usb 3-1: USB disconnect, address 2
usb 3-1: new low speed USB device using uhci_hcd and address 3
usb 3-1: configuration #1 chosen from 1 choice
localhost watchwolf # lsusb
Bus 005 Device 002: ID 046d:c518 Logitech, Inc. Bus 005 Device 001: ID 0000:0000
Bus 004 Device 001: ID 0000:0000
Bus 003 Device 001: ID 0000:0000
Bus 001 Device 001: ID 0000:0000
Bus 002 Device 002: ID 0603:00f2 Novatek Microelectronics Corp. Bus 002 Device 001: ID 0000:0000
Je rapellerais à tosu les noobs qui veulent compiler leur noyau pour faire genre je suis le plus fort, que l'un des commandes à lancer et à ne pas oublier sinon ca fontionne moins bien est: